Voisko joku ns aukilukea ton: 296/112/12.25/3.2
Nokkakepin merkintöjä. Asteet 296, nostoa 12.25, muista numeroista ei hajua.
Nokkakepin merkintöjä. Asteet 296, nostoa 12.25, muista numeroista ei hajua.
-
-
Googlailin tässä joutessani hakusanalla "296/112/12.25/3.2" ja Enemin sivuilta löytyi heti:
- 296/105/13.0/4.4 ins
296 = Duration in crank shaft degrees. Specified where the acceleration of the Valve starts, normally 0,20 mm higher than the Tappet clearence. - 105 = Angle between lobe centers.
- 13,0 = Valve lift at 0-clearence.
- Value for valve opening at TDC (mm). For 2-valve single Cam engines always for the inlet valve. Tappet clearence shall be adjusted when measuring. If there are two Cams a second value must be used, normally for the Exhaust Cam and the value specify how much the Valve still have to close at TDC.
A general rule is, if the value is missing, it shall be 0,5 - 0.7 lower than the value for Inlet valve. - ins or avg indicates if it is an Inlet or Exhaust Cam. The same profile is common on both types of Cams.
- ÖD = Piston in top.
ReWoN Motors - BMW-huollot ja korjaukset, alumiinivanteiden korjaushitsaukset, pakosarjat, ahtoputket, alumiini- ja rst-hitsaukset ja sorvaukset - 296/105/13.0/4.4 ins
Comment